자료실
오시는 길
HOME PRODUCTS BREATHALYZER(

ignition interlocking device

)
ignition interlocking device
ALX1000
ALX1000 is the Fuel cell type alcohol sensor breathalyzer with the ignition interlock device for automobiles. After getting in the car with ALX1000 installed, the driver must be tested for alcohol and the ignition controlled depending on the result of the analysis. Unlike previous ignition interlock devices, ALX1000 is more reasonably priced, as well as providing convenience of enabling users to change the sensor themselves.
SPECIFICATIONS
Indication of B.A.C.
(Full 3 decimals)
0.000 to 4.000 ‰ or
0.000 to 0.400%BAC or
0.000 to 2.000 mg/l BrAC by LED display
Sensor Fuel cell type alcohol sensor
Accuracy ±0.005%BAC at 0.100%BAC
Mouthpiece Use
Power Two 1.5V "AAA" size alkaline batteries and 12V cigar jack in car
Weights 100g (Including Batteries)
Dimension(mm) 116 (height) X 50 (width) X 20 (thickness)
Audible warnings 3 steps beep warning of alcohol detection with LED display
Ambient conditions Storage : 5 to 50 ℃
Operation : 5 to 40 ℃
Available color Black
Certificate CE
CONTENTS
1x Breathalyzer
5x Mouthpieces
1x Pouch
1x connecting cable
2x 12V DC code
1x Control unit
1x Manual

PACKAGE
25pcs/Carton *Size : 600 x 480 x 300(mm) / Weight : 23kg
Over 1K pcs order’s case, we will provide buyer designed gift box and logo imprinted without extra charge.
INSTALLATION GUIDE
BROWN : START wire
YELLOW : START wire
BLUE : IGNITION input
BLACK : GROUND input
RED : 12Volt input
1. BROWN and YELLOW wire - START wire
This wire should be connected directly to the vehicle's starter wire.
To find the starter wire, have your meter set to DC volts and connect the black lead to chassis ground.
Probe with the red lead until you locate a wire that shows (+)12 volt with the key in the CRANK position ONLY.
2. BLUE - IGNITION input
This wire should be connected directly to the vehicle's heater/air conditioning circuit wire.
To find the vehicle's ignition wire, have your meter set to DC volts and connect the black lead to chassis ground.
Probe with the red lead until you locate a wire that shows (+)12 volt with the key in the RUN position.
3. BLACK - GROUND input
Connect this wire to the vehicle's clean bare metal surface using a ring terminal.
Be sure to remove any paint or grease from the surface below your connection.
It is recommended to use a factory bolt instead of a screw, which can loosen or be stripped.
4. RED - (+)12 Volt constant power input
Connect to vehicle's (+)positive battery post or a(+)12 Volt source at the ignition switch.
Once you think you have found a wire, test it with the key in the CRANK and RUN positions.
       
COMPANY INFO PRODUCTS DATA ROOM CUSTOMER CENTER
OVERVIEW
HISTORY
CERTIFICATE
LOCATION
BREATHALYZER
GAS SENSOR
GAS ALARM
DARA ROOM NOTICE
CONTACT US
 
- alcohol screening device
- personal alcohol breath tester
- breath alcohol tests
- breathalyzer testers
- digital alcohol breathalyzer
- breath testing alcohol
- alcohol breathalysers
- fuel alcohol tester
- ignition interlocking device
- Printable alcohol breath tester
- SENTECH